You may search the entire database
for the following different classes of samples and results:
TCR Samples – Total Coliform sample results (whose Analyte Code is
3100, 3013, or 3014) that meet your selection criteria.
TCR Samples Detection Only – Total Coliform sample results (whose
Analyte Code is 3100, 3013, or 3014) where Coliform is identified
as present and that meet your selection criteria.
TCR
Summaries – Total Coliform sample summaries (whose Analyte Code is
3100) that meet your selection criteria.
Lead and
Copper Summaries – 90th percentile Lead and Copper sample summaries
(whose Analyte Code is PB90 or CU90) that meet your selection
criteria
Summarized Field Sample Results – Summarized Field Sample Results
(MDPB summaries) that meet your selection criteria.
(These results are collected to support the federal Interim
Enhanced Surface Water Treatment Rule and Disinfectant ByProduct
Rule.)
Non-TCR Samples All – Chemical, radionuclide, microbiological, and
water quality parameter samples (whose Sample Results’ Analyte Code
is not 3100, 3013, or 3014) that meet your selection criteria.
Non-TCR Samples by Analyte – All non-TCR analytes referenced by
sample results (excluding those where Analyte Code is 3100, 3013,
or 3014) that meet your selection criteria.
If the analyte does not appear on this list, no sample results for
that analyte and your criteria exist in the database.
Non-TCR Samples Detection Only – Chemical, radionuclide,
microbiological, and water quality parameter samples (whose Analyte
Code is not 3100, 3013, or 3014) where the Result Concentration is
greater than 0 and that meet your selection criteria.